PENGARUH KECEPATAN DAN TEGANGAN LISTRIK PENGELASAN "BUTT FLASH", TERHADAP LEBAR HAZ DAN WELD SAMBUNGAN LAS BAJA KARBON RENDAH

- Sutomo(1*)


(1) 
(*) Corresponding Author

Abstract


Butt Flash Welding was uged many steel's factory to produce the metal's sheet like coiling sheet steel. In order to speed up the production of coiling sheet steel, two coils sheet steel will be connected each other by this welding. This sheet will be leduced by TCM (Tandem cold Milling). Sometimes this processing has trouble and stopped, because this sheet steel was cutout. This problem Is caused by the wide of HAZ or weld is too large. The smallest of HAZ and weld will use full. In order to this reason research would
like to know the effective parameter of velocity and voltage of Butt Flash Welding. The result of this research is vilocity at v = 76/24 mm/sec and voltage at T=7,86 volt will produce a smallest of HAZ & Weld.
Key word: Butt flash Welding, velocity, voltage, HAZ and Weld.

Full Text:

PDF

Article Metrics

Abstract view : 306 times
PDF - 37 times

DOI: https://doi.org/10.26714/traksi.2.1.2004.%25p

Refbacks

  • There are currently no refbacks.


Copyright (c)

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.


TRAKSI : Majalah Ilmiah Teknik Mesin

ISSN : 1693-3451 (Pinted) e-ISSN : 2579-9738 (Online)

Published by: LP2M Unimus bekerjasama dengan APTI (Asosiasi Profesi Teknik Indonesia)  

 
ADDRESS

Jl. Kasipah No. 12 Semarang

E-mail: traksi@unimus.ac.id Call: 0248445768


Sponsors

Asosiasi Profesi Teknik Indonesia (APTI)

Website: www.apti.or.id